As requested in ID:146 and ID:147, the laserscan tab was improved:
- The laserscan tab shows each observable plotted against the predefined wavelength setpoints now.
- The Kobra set wavelength shows the actual setpoints now and not measured wavelengths.
Note: The bins of the laserscan histograms are defined in TLdaAnlProc.cxx, lines 140-142.
At the moment, the histograms are set up for scans in the range 320 - 325 nm and step sizes of 0.01 nm.
If the step size changes or scans that exceed this range are required, these parameters should be adjusted.
Remember to add or subtract half of the step size to your min. and max. wavelength to prevent binning artifacts.
Then of course, also only scan wavelengths which are multiples of your step size. |