| ID |
Date |
Author |
Category |
Subject |
Text |
 |
|
54
|
Thu May 16 16:38:11 2024 |
Ide, Hubbard | Runs | No beam to ESR | because of problems in HHT
no beam from 16:36 |
|
|
53
|
Thu May 16 16:10:03 2024 |
Ide, Hubbard | Runs | Lassie Screenshot | Lassie Screenshot taken at 16:09 |
|
|
52
|
Thu May 16 15:24:30 2024 |
Ide, Hubbard | Accelerator | new Plunger setting | plunger motors were set
to +/-390 mm for 245 MHz resonator
|
|
|
51
|
Thu May 16 14:52:45 2024 |
Shahab | DAQ | Zr recording | Recording Zr starting from 14:45 again back
to short cycle. |
|
|
50
|
Thu May 16 13:04:02 2024 |
Mayr, Hannes | Runs | DAQ stopped, change setting to 98Zr | Beam tuning for 98Zr starting at 12:53, following
data should be excluded from analysis. DAQ
was stopped around 13:13. |
|
|
Draft
|
Thu May 16 12:48:58 2024 |
Sergey | Accelerator | Tune to 98Zr | - stop longer measurements
- change quadrupole and sextupole magnets
- rescale SIS-TE-ESR |
|
|
48
|
Thu May 16 11:20:10 2024 |
Sergey | Accelerator | Screenshot of ESR pattern with 140 repetitions (each is 100 ms) | Injection Beam Process: 100ms
Bunching Beam Process: 16ms
Intermediate Beam Process: 100 ms, which |
|
|
47
|
Thu May 16 11:13:05 2024 |
Mayr, Hannes | Runs | Rates | With the new timing, the rates now look like
can be seen in the screenshot. |
|
|
46
|
Thu May 16 11:08:27 2024 |
Mayr, Hannes | Runs | DAQ running again | "Real" measurement with good data starting
from 11:07 until approximately 13:00.
Measurement time was changed to 10s with |
|
|
45
|
Thu May 16 10:18:14 2024 |
Mayr, Hannes | Runs | Beam back, DAQ off | Beam is back since 10:10, but DAQ is turned
off to change the setting there.
Measurements starting at 10:18 are only test |
|
|
44
|
Thu May 16 09:41:56 2024 |
Mayr, Hannes | Runs | No beam | No beam from 09:39 to 10:10 due to a setting
change. The change aims to increase the measurement
time to 10s. |
|
|
43
|
Thu May 16 08:58:39 2024 |
Mayr, Hannes | Runs | Fluctuations in particle rate | Particle rates are fluctuating and increasing
from a constant 5e8 to something around 1e9. |
|
|
42
|
Thu May 16 07:50:39 2024 |
Mayr, Hannes | Runs | Peaks with very high particle rate | Peaks in the particle diagram going to unusual
high 1.4e9 particles. |
|
|
41
|
Thu May 16 07:25:33 2024 |
Mayr, Hannes | Runs | Lassie Screenshot 07:23 | Start of regular screenshots of the Lassie
monitor every 1-2 hours. |
|
|
40
|
Thu May 16 04:37:27 2024 |
Boguslaw, Camille | Runs | No beam to ESR | We had no beam in ESR for about 3 minutes |
|
|
39
|
Thu May 16 00:37:41 2024 |
Boguslaw, Camille | Runs | Injection pattern changed | The injection pattern changed on Lassie monitor
(0:27 AM). (picture 1)
|
|
|
38
|
Wed May 15 23:04:32 2024 |
Xinliang | Analysis | Electron cooler data | The cooler curve measured during May 14 afternoon. |
|
|
36
|
Wed May 15 20:40:51 2024 |
Jeroen, Johan | Runs | Beam returned to ESR | 20:39:42 Runs restarted. |
|
|
35
|
Wed May 15 20:17:20 2024 |
Jeroen | Accelerator | Fewer spills from SIS18 then lost beam | Apparently fewer spills coming from SIS18,
see attached.
|
|
|
34
|
Wed May 15 19:45:44 2024 |
Helmut Weick | Accelerator | Cooler curves after beam shift | After the Beam position tuning but before
the scraper tuning two more cooler curves
were taken.
|
|