HKR called and said they have problems with the beam and need to enter the cave, so they stop the beam for some time
Beam Stop 00:10
Beam back 01:01

Beam dropped between 23:00 and 23:05

since 21:48 particle intensities increased to again to 1.5E9

Intensity in particles dropped from 21:33

since 21:20 the intensity is back to 1.5E9

The intensity dropped at 21:10 from ~ 1.6E9 down to ~ 8E8

19:10 runs from now on run with an optimized setting:

we did a lot of optimization for the hunt of Zr isomer:

1- increased the time as much as possible, but stay within the 1:1 cycle with FRS
2- increased the sampling rate from 6.25 MSPS to 50 MSPS (!) going down to very short recording times --> 300ms only

We are now taking data with this settings for about half an hour.

new timing cycle of 6.7s

Beam is back at 18:32 
now in the particle plot the peaks seem to be more isolated than before (see attachment 1)
since 18:36 it looks like before (see attachment 2)

beam issues between 18:23-18:26
and beam completely lost from 18:27 till 18:32
in the SIS an issue with a dipole occured

beam is back
16:45

HHT sees radiation from us. We stop for 10 min for them to see the speed with which the radiation level decreases.

because of problems in HHT
no beam from 16:36

Lassie Screenshot taken at 16:09

plunger motors were set

to +/-390 mm for 245 MHz resonator
and +/-55 mm for 410 MHz resonator

Recording Zr starting from 14:45 again back to short cycle.

Beam tuning for 98Zr starting at 12:53, following data should be excluded from analysis. DAQ was stopped around 13:13.

- stop longer measurements
- change quadrupole and sextupole magnets
- rescale SIS-TE-ESR

Injection Beam Process: 100ms
Bunching Beam Process: 16ms
Intermediate Beam Process: 100 ms, which is repeated 140 times
Intermediate Beam Process: 16 ms

With the new timing, the rates now look like can be seen in the screenshot.