| ID |
Date |
Author |
Category |
Subject |
Text |
 |
|
55
|
Thu May 16 16:43:29 2024 |
Yuri | Accelerator | HHT | HHT sees radiation from us. We stop for 10
min for them to see the speed with which
the radiation level decreases. |
|
|
38
|
Wed May 15 23:04:32 2024 |
Xinliang | Analysis | Electron cooler data | The cooler curve measured during May 14 afternoon. |
|
|
8
|
Tue May 14 19:07:27 2024 |
Shahab | Runs | Broadband measurement / High Sampling rate | Stable beam after a long time:
|
|
|
9
|
Tue May 14 21:41:11 2024 |
Shahab | Runs | Test Screenshot | |
|
|
51
|
Thu May 16 14:52:45 2024 |
Shahab | DAQ | Zr recording | Recording Zr starting from 14:45 again back
to short cycle. |
|
|
48
|
Thu May 16 11:20:10 2024 |
Sergey | Accelerator | Screenshot of ESR pattern with 140 repetitions (each is 100 ms) | Injection Beam Process: 100ms
Bunching Beam Process: 16ms
Intermediate Beam Process: 100 ms, which |
|
|
Draft
|
Thu May 16 12:48:58 2024 |
Sergey | Accelerator | Tune to 98Zr | - stop longer measurements
- change quadrupole and sextupole magnets
- rescale SIS-TE-ESR |
|
|
7
|
Tue May 14 15:07:23 2024 |
Ruijiu, David, Shahab, Xinliang, Zhangmin | Runs | Cooler curve measurement |
Cooler curve measurement
|
7x |
|
2
|
Mon May 6 12:16:09 2024 |
Ruijiu Chen | DAQ | ntcap scaler | |
|
|
4
|
Thu May 9 10:01:59 2024 |
Ruijiu Chen | DAQ | NI crate of NTCAP system can not be started. | After moving the NTCAP system from HKR to
ESR Messhutte, we tested the system with
a signal generator on 16th February and confirmed |
|
|
5
|
Thu May 9 15:59:30 2024 |
Ruijiu Chen | DAQ | Carsten checked the NTCAP system. | Exactly this was the question. If several
devices fail at the same time and you look
for the course you might get suspicious.
|
|
|
6
|
Sun May 12 18:34:54 2024 |
Ruijiu | Analysis | How to use queqiao to transfer tiq data | If the ssh to lxir131 was disconnected, you
can connect to lxir131 and restart queqiao
program to transfer tiq data from NAS to |
|
|
41
|
Thu May 16 07:25:33 2024 |
Mayr, Hannes | Runs | Lassie Screenshot 07:23 | Start of regular screenshots of the Lassie
monitor every 1-2 hours. |
|
|
42
|
Thu May 16 07:50:39 2024 |
Mayr, Hannes | Runs | Peaks with very high particle rate | Peaks in the particle diagram going to unusual
high 1.4e9 particles. |
|
|
43
|
Thu May 16 08:58:39 2024 |
Mayr, Hannes | Runs | Fluctuations in particle rate | Particle rates are fluctuating and increasing
from a constant 5e8 to something around 1e9. |
|
|
44
|
Thu May 16 09:41:56 2024 |
Mayr, Hannes | Runs | No beam | No beam from 09:39 to 10:10 due to a setting
change. The change aims to increase the measurement
time to 10s. |
|
|
45
|
Thu May 16 10:18:14 2024 |
Mayr, Hannes | Runs | Beam back, DAQ off | Beam is back since 10:10, but DAQ is turned
off to change the setting there.
Measurements starting at 10:18 are only test |
|
|
46
|
Thu May 16 11:08:27 2024 |
Mayr, Hannes | Runs | DAQ running again | "Real" measurement with good data starting
from 11:07 until approximately 13:00.
Measurement time was changed to 10s with |
|
|
47
|
Thu May 16 11:13:05 2024 |
Mayr, Hannes | Runs | Rates | With the new timing, the rates now look like
can be seen in the screenshot. |
|
|
50
|
Thu May 16 13:04:02 2024 |
Mayr, Hannes | Runs | DAQ stopped, change setting to 98Zr | Beam tuning for 98Zr starting at 12:53, following
data should be excluded from analysis. DAQ
was stopped around 13:13. |
|