ID |
Date |
Author |
Category |
Subject |
Text |
|
99
|
Sun May 19 11:02:49 2024 |
Xu Zhou, Yuhu Zhang, Kanika | Accelerator | the beam is paused | The beam is paused and HHT team needs to enter
the ring. |
|
82
|
Fri May 17 23:14:51 2024 |
Yoshi, Ohnishi | General | shift started | Just test |
|
98
|
Sat May 18 16:45:15 2024 |
Helmut, Yury | Accelerator | setting for 96Sr (98Y) | To have a few more lines the setting actually
is not on 96Sr directly, but on 98Y39+.
98Y is also the one set to be isochronous. |
|
33
|
Wed May 15 19:20:32 2024 |
Helmut Weick | Accelerator | scraper setting | After the orbit correction on the target straight
section the scrapers work better.
One pair of scrapers works best:
|
|
90
|
Sat May 18 02:22:30 2024 |
Helmut Weick | Accelerator | paper log book pages 17.05.2024 | until we lost the beam in the night. |
|
12
|
Tue May 14 23:40:03 2024 |
Helmut, Sergey, Yury | Accelerator | paper log book | two pages of log book on paper for teh first
setup,
injection into ESR and tuning primary beam |
|
26
|
Wed May 15 12:58:12 2024 |
Beatriz, Min, Shahab | Runs | optimizing the mass resolution | Yuri and Sergey still optimizing the mass
resolution.
|
|
2
|
Mon May 6 12:16:09 2024 |
Ruijiu Chen | DAQ | ntcap scaler | |
|
73
|
Fri May 17 17:50:49 2024 |
Jelena B, Zsolt P., Shahab | DAQ | new trigger events | From 17:49 we have super short trigger. -
see attached setting! |
|
59
|
Thu May 16 18:55:38 2024 |
Ide, Hubbard | General | new timing cycle | new timing cycle of 6.7s |
|
52
|
Thu May 16 15:24:30 2024 |
Ide, Hubbard | Accelerator | new Plunger setting | plunger motors were set
to +/-390 mm for 245 MHz resonator
|
|
11
|
Tue May 14 23:22:55 2024 |
Helmut Weick | Accelerator | isochronicity curves | Sergey started with a setting with quadrupoles
already changed like in 2021.
Ths was used for the first isochronicity |
|
10
|
Tue May 14 22:13:38 2024 |
David, Ruijiu, David, Asahi | DAQ | doing some test runs without accelerator trigger | empty shots for test. |
|
102
|
Sun May 19 14:17:57 2024 |
Shahab, Kanika,hongfu li,xing xu | DAQ | center frequency change for 96Sr | aiming for 96-Sr:
|
|
72
|
Fri May 17 17:09:26 2024 |
Helmut, Yury | Accelerator | approx. 96Sr setting (98Zr39+) | Only 96Sr would yield very few line with only
ions from time to time.
So we went a bit lower in Brho 7.69 Tm -> |
|
Draft
|
Fri May 17 17:03:39 2024 |
Helmut, Yury | Accelerator | approx. 96Sr setting | Only 96Sr would yield very few line with only
ions from tiem to time.
So we went a bit lower in Brho 7.69 Tm -> |
|
51
|
Thu May 16 14:52:45 2024 |
Shahab | DAQ | Zr recording | Recording Zr starting from 14:45 again back
to short cycle. |
|
28
|
Wed May 15 16:55:10 2024 |
Jeroen, Johan | General | Tuning ESR scraper. Isomer resolved. | 4:50 Scraper tuned to produce Gaussian beam
profile for 98Mo. Isomer now clearly resolved.
|
|
Draft
|
Thu May 16 12:48:58 2024 |
Sergey | Accelerator | Tune to 98Zr | - stop longer measurements
- change quadrupole and sextupole magnets
- rescale SIS-TE-ESR |
|
86
|
Sat May 18 00:37:21 2024 |
Helmut, Wolfram, Shahab, David, Xinliang | Runs | Trying to get back to Zr setting | |
|