HOME ESR EXPERIMENTS LABS etc
E121 E127 E132 E125 E143 laser_cooling_2021 E142 Ê128 E146 E0052 E0018 E0028 E0038 E0075 E0203_E0018 E0052_2025
  Nuclear hyperfine mixing in 229Th89+ 2025, Page 2 of 4  Not logged in ELOG logo
Entry  Tue Jun 24 15:44:06 2025, Konstantin, DAQ, Phase shift in DAQ1 
In the SetParameters.C file is a parameter called fPar->piPhaseOffset. It was shifted from 100 to 50 in order to see ion bunches in the pmt signal and laser
pulses in the photodiode signal during the same revolution in the TDC spectrum. Note that this parameter must be taken 
into account when setting the window conditions of the arrival time in the SetConditions.C file. 
Entry  Mon Jun 23 18:36:39 2025, Wilfried, Simon, Detectors, PMT test with LED 
We tested the PMTs again, this time with an UV LED that is mounted at a window close to the XUV detector.
PMT south showed a very clear increase in count rate from about 1 to 50 Hz.
PMT mid also showed a small increase by a few Hz.
Entry  Mon Jun 23 10:59:36 2025, Julian, Lukas, Zsolt, Nadine, Konstantin, Runs, Scan routine 
-Start new injection
  ->wait for 60 injections to be complete
  ->note down SIS intensity (at extraction)
Entry  Mon Jun 23 10:52:34 2025, Julian, Lukas, Zsolt, Nadine, Konstantin, Laser, Frequency conversion unit 
We exchanged the old BBO of the Cobra's FCU with a new one. The output power of the Cobra was around 120mJ. In the end, we achieved a UV power of about
21mJ. In addition, we optimized the fiber-coupling to the wavemeter. 
Entry  Mon Jun 23 01:01:17 2025, Carsten, Detectors, CAEN PMT Power supply 
Since yesterday, channel 0 of the CAEN PS is dead (no voltage even without cable).
Changed detector south to channel 3.
Entry  Sun Jun 22 23:48:35 2025, Carsten, Accelerator, Summary of todays settings and tests  
Scraping, beam intesnity optimizations and nuching were set up and optimized during the day.

[B]Initial findings[/B]
Entry  Sun Jun 22 22:29:04 2025, Carsten, Accelerator, Backup copy of present accelerator settings - don't use if you don't know what you are doing 
# Version: 1.3
# Comment: ParamModi Export at 2025-06-22T22:28:05.633712878+02:00[Europe/Berlin]
# Context: ESR_25_12_THORIUM_20June_v3.C1
Entry  Sun Jun 22 21:36:48 2025, Carsten, Finn, Zac, Esther, Runs, First laser scans 

[B] Scan parameters:[/B]
[TABLE border="1"]
Entry  Sun Jun 22 18:47:23 2025, Carsten, Peter, Marek, Simon, DAQ, PMT and particle detector settings 
Final voltages and thresholds for the PMTs and particle detectors before the first scan:

[TABLE border="1"]
Entry  Sun Jun 22 11:31:59 2025, Arya, Carsten, Julien, Konstantin, General, Summary morning shift 
1. UNILAC running again, so we resumed the beam tuning wherre we stopped yesterday at 14:00

2. Goals: Reduce intensity and lifetime of "antibunch" contamination while maximising intensity for main bunch/on PD
Entry  Sat Jun 21 22:33:04 2025, Peter , Danyal, Detectors, PMTs are switched off 
We have switched off all 3 PMTs  !
Entry  Sat Jun 21 21:55:18 2025, Peter, Danyal, Marek, Detectors, PMT rates no_rings_under_PMT_north.png2_rings_under_PMT_north.png
We have made two foam rings (outer diameter ca. 70 mm with a thickness of 10 mm each and placed them successively underneath PMT north. 

ring 1: ID = 55 mm 
Entry  Sat Jun 21 18:00:49 2025, Carsten, Peter, Danyal, Kristian, Marek , Detectors, PMT signals Panel4.gif
Carsten and Kristian changed (18:00) the thresholds of PMT north and PMT middle in the ESR cave. 
See picture below. The effect is negligible. 
Entry  Sat Jun 21 17:00:10 2025, Carsten, Peter, Danyal, Kristian, Marek, Detectors, PMT north exchanged Panel4.pngPanel4.jpg
We noted that the dark countrate of PMT north is about 20x higher than that of PMT middle. 

We went into the ESR cave to look for stray light. 
Entry  Sat Jun 21 11:42:50 2025, Arya, Julien, Wilfried, General, Test laser scan 
Test scan to see whether laser spot is moving while scanning

Aborted accumulation because SIS stopped. 12.9k counts
Entry  Sat Jun 21 08:48:16 2025, Arya, Julien, Wilfried, Accelerator, Low 229Th particle numbers and 229Th lifetime in ring Bildschirmfoto_timing_full_2025-06-21_09-30-46.pngBildschirmfoto_timing_end_of_manipulation_2025-06-21_09-36-24.pngBildschirmfoto_timing_full_60_2025-06-21_11-25-51.pngBildschirmfoto_PDSouth_lifetimes_2025-06-21_11-26-43.png
With reference to entry 37 Laser timing:

- at last 30 injections accumulation: 10k counts on particle detector (accumulated during manipulation until it saturates, e.g. no more Th in ESR)
Entry  Sat Jun 21 07:28:35 2025, Arya, Julien, Wilfried, Laser, Laser Timing Bildschirmfoto_IonBunch_PDs_2025-06-21.pngBildschirmfoto_rough_timing_2025-06-21_07-22-59.pngBildschirmfoto_timingcorrected_2025-06-21_08-21-53.pngBildschirmfoto_timing_final_2025-06-21_08-46-18.png
We roughly adjusted the timing based on attachment 1, for ions to be in center of electron cooler (east arc), corrected for PMTs being 2.5m closer to the
north on the west arc
then did a new 30 injection accumulation (10.8k counts on particle detector) and readjusted the timing to fine tune this
Entry  Sat Jun 21 03:13:02 2025, Alex, Anton, Rodolfo, Hiroshi, Detectors, Part Det South Bildschirmfoto_PartDetSouth_2025-06-21.png
Bunch signal on Particle Detector South. On the 

[LIST]
Entry  Sat Jun 21 03:06:19 2025, Rodolfo, Alex, Hiroshi, Anton, Laser, beam overlap with t-scrapers 2025-06-21_05-14-39-706.png2025-06-21_05-22-21-447.png2025-06-21_05-27-59-895.png2025-06-21_05-31-37-019.pngMRC-settings_Th-Beam_2025-06-21.JPG
[TABLE border="1"]
motor|ion beam position (mm) from outside|ion beam position (mm) from inside
|-
Entry  Sat Jun 21 02:32:24 2025, Alex, Anton, Rodolfo, Hiroshi, Carsten, Laser, Laser scanning setting 
This is the initial scanning range
[LIST]
[*] 3 Loops
ELOG V3.1.5-fc6679b